Setting up your IAX Trunk inside PBX in a Flash

Setting up your IAX Trunk inside PBX in a Flash

This article will help you setup an IAX2 trunk in your PBX in a Flash system and connect it with IPComms SIP trunks..

  • Setting up a IAX Trunk is very similar to a SIP Trunk, the biggest difference in registration is the Register String. The IAX trunk contains more information than a SIP Trunk. Trunk information can be copied over just like setting up the SIP Trunks
Read more

Setting up your IAX Trunk inside PBX in a Flash/FreePBX

Setting up your IAX Trunk inside PBX in a Flash

  • Setting up a IAX Trunk is very similar to a SIP Trunk, the biggest difference in registration is the Register String. The IAX trunk contains more information than a SIP Trunk. Trunk information can be copied over just like setting up the SIP Trunks
  • Make sure to set the registration string as; username:password@domain
  • If you would like to see if trunks are registered you can go to the FreePBX System Status and look at IP Trunk Registrations.
Read more